Honda cbr 1000 rr Trackday bike

I no longer race so this really is just sitting around going to waste!

2005 cbr1000rr Fireblade I have owned this bike since Jan 2007. bought off a superstock cup rider who had her for the start of the 06 season.
I have replaced the stock engine with a fully tuned 188bhp motor. was last refreshed and dyno'd at Seton's. its revving out on the dyno as the stock ecu is holding it back. put an hrc unit on and it will go 190bhp+ not bad for an 05 model by todays standards
The engine itself has wiseco high compression pistons and rods. ported. flowed. blueprinted. braced clutch basket for improved starts. nrc stator cover. It cost me a total of £3500 for this engine and setup alone!
She has enough fairings to do you through a season though all could do with a repaint to be fair. no v5 as she was never registered. bought from len wade motorcycles and stripped straight for track.
Not pristine or showroom condition as she has been used on track. the fairings on her at the mo are not the best and look better in the picture than they are up close.
below spec. might be forgetting the odd bit but there really is alot to remember.

WP competition rear shock with remote adjuster
WP fork cartridge kit
Yoshimura full stainless system
piperx filters
Gilles rearset
Gilles chain adjusters
520 chain
brembo brake m/cyl
06 model 320mm front discs
silicone coolant hoses
gpr damper
hrc q/a throttle
dynojet PC3 and ignition module
Cordona gp quickshifter with sbk4 shift box
carbon fibre air intake
ten kate bell mouths
lsl clip ons
harris nose bracket
GPT lap timer and beacon with computer download lead. (worth lots but used very little!)

it has covered 2049 miles from new (as displayed on the dash). the stock engine came out at 1599 miles. Tuned engine was refreshed before going in and has cover the remaining 450 miles.

I do have a spares package available. engine (1599 miles from new). frame. subframes. sprockets. forks. iring looms. tank. Yoshi RS5 end can. clipons. standard throttles+cables. Ten kate rearsets. etc. etc basically enough to cover most eventualities that i will now include. (get another swingarm. bottom yoke. wheels and rear and shock and you have a whole spare rolling chassis) I will not split parts or budge on price. it is priced to sell fast as it is given what is there.

Bike is located in Ipswich and will need to be collected. I have a ramp to get her on a van if needed.